Harman-kardon Car Stereo System Manuel d'utilisateur télécharger pdf (Page 6)

Installing Components

Installing the Electronics Enclosure

At the selected site, install the Electronics Enclosure. Use either the

enclosed cable ties or mounting screws, as shown below.

Installing the Text Display

1. Temporarily place the Text Display at the proposed site

and check the default viewing angle while adjusting the

pivot arm. If it meets your needs, then skip to step 2.

Otherwise, change the viewing angle as follows:

a. Using the 3mm hex key, loosen the recessed hex screw

(inside the display base) until the pivot arm is free from

the display assembly. The hex screw will remain captive.

b. Select another viewing angle position (middle or top).

Reassemble the parts in reverse order and tighten the

recessed hex screw.

2. At the base, using the 1.5mm hex key, loosen (but do not

remove) the hex setscrew.

3. To install the Text Display with adhesive tape, perform the

following steps or skip to step 4:

a. Insert the mounting plate, rotate it 180°, and tighten

the hex setscrew as shown below.

6 INSTALLATION

Recessed

Hex Screw

Display

Assembly

Display

Base

3mm

Hex Key

Mounting

Plate

Adhesive

Pad

Hex Setscrew

Drive+Play OM revB.qxd 9/14/05 7:20 PM Page 6

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Harman-kardon Car Stereo System Manuel d'utilisateur Page 6