Harman-kardon Car Stereo System Manuel d'utilisateur

Owner’s ManualDrive+Play OM revB.qxd 9/14/05 7:20 PM Page 1

Initial Setup (continued)Setting AUX Input To route an audio signal from a device (e.g., cell phone orsatellite radio; see Wiring Diagram on page 5) c

Setting the Sleep TimerDrive + Play is equipped with a sleep timer that delays itspower off by a default of 2 seconds after the ignition isturned off.

TROUBLESHOOTINGProblem:Message = iPod DisconnectedSolution:• Check that the iPod Connection Cable is connectedbetween the Electronics Enclosure and th

INTRODUCTIONThank you for purchasing Harman Kardon’s Drive + Play™, an elegant mobile audio solution that provides the driver withtotal iPod®control,

INSTALLATIONParts ListDrive + Play includes the following components and parts:• Text Display With Universal Mounting Base and AttachedCable (3m)• Con

Choosing Installation Locations (continued)Electronics Enclosure LocationThe Electronics Enclosure contains the wireless FM transmitterand the power s

Wiring DiagramDirect Connection of the 12-Volt Power Harness With In-Line Fuse HolderUse this method when you want a permanent power connec-tion to th

Installing ComponentsInstalling the Electronics EnclosureAt the selected site, install the Electronics Enclosure. Use either theenclosed cable ties or

b. At the proposed site, wipe the surface and exposedmounting plate with one of the enclosed alcohol pads.Allow both to dry.c. Remove the protective

Installing ComponentsInstalling the Control Knob (continued)2. At the base (below the cable), using the 1.5mm hex key,loosen (but do not remove) the h

Drive + Play operates much like the iPod itself. The ControlKnob mimics the iPod’s Click Wheel, and its software uses asimilar menu-select system. Bef